Pertronic-Anbesec linear heat detection (LHD) cable is a heat sensing device with a fixed temperature alarm threshold.

The cable consists of two twisted steel wires separated by heat sensitive insulation. The insulation melts at a pre-determined temperature, allowing the wires to contact each other and create a short circuit. When correctly connected to a Pertronic fire panel, the LHD cable triggers an alarm signal when the insulation melts.

Pertronic-Anbesec LHD cable may be connected to all current Pertronic fire panels including

• F1
• F4
• F16e
• F100A
• F220

LHD cable sensitivity is not affected by installation temperature or the length of cable heated by a fire.

Features

• Available with integral catenary wire
• Compatible with Pertronic conventional and analogue addressable fire panels
• Typically 1,600 metres of cable may be connected to a Pertronic conventional detection zone
• No adjustments required
• Supplied on 200, 400 and 500 metre drums
• Standard (non-catenary) LHD cable also available on 500 metre drums
• Pertronic-Anbesec LHD cable is UL listed under “UL 521 Heat Detectors for Fire Protective Signaling Systems” (referenced in NZS 4512:2010 section 216.1)
• FPANZ listed

NOTE: This information applies to NZS 4512 versions of Pertronic fire panels and modules. For information about connecting LHD cable to our export products, please contact your nearest Pertronic office.

---