The Analogue Addressable Single Channel Output Module (M201EA) provides a switchable output channel controlled by a fire panel over an analogue addressable circuit.

The M201EA may be configured in either of two operating modes:

• Switched, supervised control of an external power supply (up to 32 V dc)
• Voltage-free form C (changeover) relay contact

In supervised mode, while on standby, the module supervises the output load wiring. When activated by the fire panel, the M201EA switches out the load supervision and switches in the external power supply. The M201EA also monitors the external power supply voltage, and raises an unlatched fault condition if the voltage falls below 7 volts.

In the unsupervised mode, the device provides a single set of form C (changeover) contacts without load or power supply supervision.

The M201EA has a single tri-colour green/red/yellow indicator, which can be set by panel command to pulse green each time the module is polled. If the module is configured (in Pertronic FireUtils) as a sounder output, the indicator lights up steady green when the output relay is activated. The indicator blinks yellow if the module detects a fault condition.

This module features a built-in isolator on the analogue addressable circuit. The isolator may be bypassed (Please refer to the installation instructions for details).

Screwdriver operated rotary switches allow the module address to be configured from either the front or one side of the module.

Two mounting holes and a pair of DIN rail clips allow the module to be installed in any type of enclosure, including a purpose-built surface-mount box (M200E-SMB). The indicator LEDs and address switches are accessible and visible in both DIN-rail and surface mount installations.

Features:

• Individually addressable by the fire panel
• Capable of switching 2 amps (resistive) at 30 V dc
• Optional output load supervision for short-circuit and open-circuit faults
• External power supply fault monitoring when configured in supervised mode
• Tri-colour indicator LED visible from front and one side
• Automatic detection of short-circuits on AA circuit
• AA circuit short-circuit isolator
• Optional isolator bypass
• Screwdriver operated rotary address switches, accessible from front and one side
• Clips for top hat 35 mm DIN rail
• Two mounting holes
• Compatible with Pertronic F220, F100A and F120A analogue addressable fire panels
• Up to 99 module addresses per AA circuit (F220, F100A, F120A)
• Uses one address on the analogue addressable circuit
• Supplied complete with one 47 kΩ end of line resistor, and one wire link
• Complies with AS ISO 7240.17:2015 and AS ISO 7240:18:2015
• FPANZ listing PI/667
• Direct replacement for M201E in existing Pertronic systems